Pioneer LD-V8000 Level III User Manual page 22

Chapter Two • LD-V8000 Level I & III
the on-screen function switch settings. (See Section 2.4 On-Screen
Function Switches for details.) Or turn ON (1) bit 7 of Register C via
computer control to make the LD-V8000 enter this mode. Turn OFF (0) bit
7 of Register C to change the operating mode from Test Mode to Normal
Control Mode.
4) Automatic Mode
In Automatic Mode, a Level II program stored in player memory is
automatically executed. To make the LD-V8000 player enter Automatic
Mode, spin up a Level II disc that has been encoded with a Level II program,
press the RUN button on the RU-V6000T remote control unit, or send a
RUN command via the RS-232C when the player is in Normal Control Mode.
The player will look for Level II encoded data, automatically place it into
memory and execute the program.
The "Level II Auto Start" On-Screen Function Switch can also be set to
"Load from Disc", "Load from Memory", or to "OFF". When this switch is set
to "Load from Disc", and a disc encoded with a Level II program is placed in
the player and spun-up, the player will automatically load the program into
memory and execute the program. (See Section 2.4.1 Setting On-Screen
Function Switches.)
The operating mode of the player changes from Automatic Mode to Normal
Control Mode when a HALT command is executed.
5) Program Mode
In Program Mode, a Level II program is written and modified in memory.
Press the PROGRAM button on the RU-V6000T remote control unit or send
commands from a computer via the RS-232C when the player is in Normal
Control Mode to make it enter Programming Mode. Input an END command
from the RCU to stop programming and to change back to Normal Control
Mode. Press any key on the computer keyboard to exit Programming Mode.
Press the RUN button on the RU-V6000T remote control unit to execute the
program entered, or send the RUN command from an external computer.
6) Register Mode
In this mode, the registers referred to during the execution of a Level II
program are written or modified. Send a RECALL command from the
RU-V6000T to make the player enter Register Mode. Input a CLEAR command
from the RU-V6000T to change from Register Mode to Normal Control Mode.
(For information about Level II Programming on the LD-V8000, see Pioneer's LD-
V8000 Level II User's Manual/Programmer's Reference Guide v.1.1 8/92.)
See Figure 2-A on the next page, describing LD-V8000's operating modes.
2-2
TP 113 v. 2.0 • 2/93
LD-V8000 Level I & III User's Manual