Function Switches - Pioneer CLD-V5000 Programmer's Reference Manual

2.3 Function Switches

The CLD-V5000 videodisc player has eight physical dip-switches on the rear panel of
the player (See Figure 2-G below.) The switches are set as follows when the player is
shipped from the factory: Switch 1 and 4 are DOWN (ON) and Switch 2, 3, 5, 6,
7and 8 are UP (OFF). These defaults set the player to: 4800 BAUD, 1-Side Repeat ON,
Power-on/Load Start OFF, Background Color BLUE, and Sequential Playback OFF.
See Sec. 3.7.6 Register Control Commands., page 3-39.
1 2 3
Switch # Function
Sw
1 BAUD Rate
Sw 2 BAUD Rate
Sw 3
1 or 2 side playback
Sw 4
Repeat 1 or 2 sides
Sw 5 Power-On Start
Sw 6 Background
Sw 7
Sequential
Playback
Sw 8 Not Used
Figure 2-G
SW1 and SW2: These two switches are used to set the BAUD rate of the Player for RS-232C
communications to 9600, 4800, 2400, or 1200 BAUD. The factory set default is 4800 BAUD, with Switch
1 DOWN and Switch 2 UP.
SW3 and SW4: These two switches are used to set the REPEAT MODE of the Player to stop after one
side of the disc completes playback, after both sides complete playback, or to allow continuous one-side
repeat playback or continuous two-sided repeat playback. The default is One-Side Repeat ON
SW5: Automatic playback begins when a disc is loaded in the tray, the tray table is pushed in and power
is turned ON. Default is OFF. UP=OFF. DOWN=ON.
SW6: Background for setting squelch color: Black is DOWN=ON; Blue is UP=OFF. Default is Blue = UP.
SW7: Sequential Playback. Default UP=OFF. To enable sequential playback, Set SW 7 DOWN=ON and
use a special RS-232C cable to connect two or more players. With sequential playback enabled, and when
playback of a disc completes, the next player immediatly starts playback. See Appendix E for details.
SW8: This switch is NOT USED and must always be UP=OFF.
2-6
Function Switch Settings
4 5 6 7 8
DOWN UP
These two switches are
used to set the BAUD RATE:
9600, 4800, 2400 or 1200
These two switches are
used to set the
REPEAT MODE
Auto Start OFF
Black Blue
ON OFF
Must be OFF
TP 121 v. 1.0 • 1/96
CLD-V5000 Level II • Chapter Two
CLD-V5000 has 8 function switches on the back of
the player. After changing the switches to new
settings, power down and then power on the
player again to commit the settings to the player's
memory. Default settings are shown here.
Factory Setting
SW1=DOWN,
SW2=UP
sets 4800 BAUD
SW 3=UP,
SW 4=DOWN
Sets
1-Side Repeat ON
UP/OFF
UP/Blue
UP/OFF
UP/OFF
CLD-V5000 Level III User's Manual
Set BAUD Rate w/ SW 1 & 2
BAUD SW 1 SW 2
9600 UP UP
4800 DOWN UP
2400 UP DOWN
1200 DOWN DOWN
Playback & Repeat w/ SW 3 & 4
Mode SW 3 SW 4
Stops after one-side
completes playback UP UP
Stops after both-side
complete playback DOWN UP
One-side Repeat UP DOWN
Two-side Repeat DOWN DOWN