On-Screen Function Switches; Setting On-Screen Function Switches - Pioneer LD-V4400 Level I User Manual

Industrial laser disc player level i & iii
Hide thumbs Also See for LD-V4400 Level I:
Table of Contents

Advertisement

2.4 On-Screen Function Switches

The LD-V4400 videodisc player contains no physical dip-switches for setting
various function parameters. Instead, the function parameters can be set by
controlling on-screen menus with the buttons on the front panel of the player, or
with buttons on an RU-V103 remote control unit.
NOTE: Some settings can be modified by entering data into Registers from a
computer via the RS-232C port. (See Section 4.7.6 Register Control Commands,
page 4-39.)

2.4.1 Setting On-Screen Function Switches

Use the following steps to set the on-screen function switches:
1) Function Switch Setting Mode
First, turn the player OFF using the power button on the front of the player.
Then press the DISPLAY button on the front panel of the player while turning
the power back ON. This sets the Function Switch Setting Mode and prepares
the player to receive inputs to set the on-screen function switches. (In Function
Switch Setting Mode, the LD-V4400's front panel LEDs cycle ON and OFF.)
You will see a screen titled "KEY OPERATION P-0." This on-screen "page"
explains which buttons on the front panel of the player allow you to locate,
select and set the function switches. (See Figure 2-O, on page 2-13.)
2) Setting Switches Using The Player's Front Panel Buttons or Remote Control
Page Selection
By pressing the SCAN FORWARD button you can move forward through each
of the five pages, one at a time. The SCAN REVERSE button lets you move
through the pages in reverse order. Page 1 is titled "CONTENTS P-1." This
tells you the particular page on which to find the function you want to set.
Selecting Functions and Parameters
When you locate the page that contains the function you want, press the
STEP FORWARD button. This will highlight the top function on the page.
Press the STEP FORWARD button until the function you want to set is
highlighted. Pressing the STEP REVERSE button will toggle through the
available options/parameters for that particular function, allowing you to
select the one you want.
Modifying the Settings
Continue through additional pages (P-2 and P-3) to set the switches to your
required "power on" settings. Page P-4 contains a summary of the seven bit
settings for both switches. The diagram reflects parameters selected in the
previous pages. The bits can also be selected by using the Step Forward button
on the front panel or on the RCU, and set using the Step Reverse button.
Digits 4,5,6 on the remote control can also be used to select the bits.
LD-V4400 Level I & III User's Manual
LD-V4400 Level I & III • Chapter Two
TP 116
v1.1 • 9/93
2-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents