Table of Contents
Advertisement
Chapter 2 Preparations
1.17.5 Installing RAID Controller
This section describes how to install an optional RAID Controller to the slot dedicated to RAID Controller.
(1)
When using the optional RAID controller (N8103-149/150/151/160)
For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151/160).
Take the following procedure to install RAID Controller (N8103-149/150/151/160).
1.
Refer to step 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the four screws and
remove PCI riser card.
3.
Remove the two screws from
RAID Controller, and remove PCI
bracket.
4.
Remove the two screws from
server chassis, and remove RAID
Controller bracket.
5.
Attach the RAID Controller bracket
to RAID Controller with two screws
you have removed in Step 4.
Important
• You must avoid static electricity to work with the procedure below. For
details, refer to Chapter 2 (1.2 Anti-static Measures).
• Do not change the mode to hibernate during building a RAID System.
Note
• When installing an optional RAID Controller, start the BIOS Setup utility, select
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the
configuration menu for RAID Controllers cannot be launched.
Express5800/R120d-2M User's Guide
1. Installing Internal Optional Devices
Ports 4-7
Ports 0-3
93
Advertisement
Table of Contents
