Table of Contents
Advertisement
Chapter 2 Preparations
1.13.5 Installation
Install a DIMM by using the following procedure.
1.
Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Open levers on left and right sides of DIMM slot, and remove the dummy cover.
3.
Push the DIMM straight into the socket.
When a DIMM is inserted into the
socket, the lever automatically closes.
4.
Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
5.
Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
6.
Run BIOS Setup Utility and select Memory Configuration and then Memory Information from the
Advanced menu. Make sure the capacity of added DIMM is displayed properly.
Refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".
7.
Select Memory Configuration from the Advanced menu, and then specify Yes for Memory Retest.
After that, select Save Changes and Exit to reboot.
8.
Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to Chapter 1 (7.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, follow the manual of the OS.
66
Note
Keep the removed dummy cover for future use.
Important
• Make sure the orientation of the DIMM. The DIMM has a notch, preventing
being incorrectly inserted.
• Do not apply too much pressure when you push a DIMM into the socket.
Doing so can damage the socket or terminal part.
Express5800/R120d-2M User's Guide
1. Installing Internal Optional Devices
Key slot
Key slot
Key
Advertisement
Table of Contents
