Removal; Replacing A Hard Disk Drive In The Raid System - NEC N8100-1793F User Manual

Express server express5800 series
Table of Contents

Advertisement

Chapter 2 Preparations

1.25.2 Removal

To remove hard disk drive, reverse the installation procedure.
If you transfer or dispose of the removed hard disk drive, refer to Chapter 1 (1. Transfer, Movement, and
Disposal) in "Maintenance Guide" to erase data.
Run SETUP utility, and then specify the boot order from the Boot menu. For details about the Boot menu,
refer to Chapter 2 (1. System BIOS) in "Maintenance Guide".

1.25.3 Replacing a hard disk drive in the RAID System

In the RAID System, you can use the auto rebuild feature to restore data back to the state before a failure
occurred by writing the data saved before the replacement to a new hard disk drive after replacing the
broken hard disk drive.
The auto rebuild feature is enabled in logic drives set to RAID 1, RAID 5, RAID 6, RAID 10, RAID 50 and
RAID60.
The disk is automatically rebuilt when hot swapping (replacing a disk while the power on) a failed hard disk
drive.
During the auto rebuild, the DISK LED on the hard disk drive flashes green and amber alternately to
indicate that the autorebuild is being performed.
Observe the following precautions whenever executing the auto rebuild
Do not turn off the server until the auto build completes after a hard disk drive fails.
Leave an interval of at least 90 seconds between a hard disk drive removal and a hard disk drive
installation.
Do not replace a disk during the auto rebuilding of another hard disk drive (during an auto rebuild, the
DISK LED on the hard disk drive flashes green and amber alternately).
Important
NEC assumes no liability for data leakage should the product be
transferred to a third party without erasing the data.
Note
If you have to remove a disk due to a hard disk drive failure, check the slot with its
DISK LED lit in amber.
Note
Do not pull the slot out from the handle. Doing so may damage the handle.
Tips
The saved boot order is cleared when a hard disk drive is added.
Express5800/R120d-2M User's Guide
1. Installing Internal Optional Devices
DISK LED
107

Advertisement

Table of Contents
loading

This manual is also suitable for:

Express5800 seriesExpress5800/r120d-2mExp292

Table of Contents