Table of Contents
Advertisement
Chapter 2 Preparations
1.25
Hard Disk Drive
Hard disk bays are provided at the front of the server.
A hard disk drive mounted in a dedicated drive carrier can be purchased. Install the hard disk drive on the
server with it mounted in the drive carrier.
Note the following precautions to install hard disk drives.
•
For onboard connection, hard disk drives having different capacities, interface types, or rotational speeds
cannot be installed together.
•
In the RAID System, all the hard disk drives in a group (pack) must have the same capacity, interface
type, and rotational speed.
Bays can contain up to 8 hard disk drives (when HDD cage is added, 16 HDDs can be installed).
Port numbers have been assigned to each slot.
1.25.1 Installation
Install a hard disk drive by using the following procedure.
1.
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Locate the slot where you install the hard disk drive.
The server provides 8 slots (or 16 slots when additional HDD cage is installed). Install hard disk drives
in ascending port number order.
3.
Remove the dummy trays.
Dummy trays are installed in all slots.
Important
Use hard disk drives specified by NEC. Installing a third-party hard disk
drive might cause a failure of the server and it.
Important
In the RAID System, build a Disk Array using hard disk drives that have the
same specifications (capacity, rotational speed, and standard).
Note
Keep the dummy trays for future use.
Express5800/R120d-2M User's Guide
1. Installing Internal Optional Devices
105
Advertisement
Table of Contents
