Accessories Supplied With The Air Conditioner; Location Of Indoor And Outdoor Units - Electra WNG 7 Service Manual

I N S T A L L A T I O N
FOR SPLIT WALL MOUNTED AIR CONDITIONER
1
ACCESSORIES SUPPLIED WITH
THE AIR CONDITIONER
Shape
Name
Mounting Plate
Remote control
With batteries
Remote control
bracket
Screws
washers dowels
Screws, Dowels 1
Outdoor unit
drain connector
Mounting pads
Cable ties
Cable terminals
Twin wire cable
(for heat pump
units)
Air purifying
filter (optional)
Operation and
installation
instructions
Qty
Used for
Wall mounting
of the indoor
1
unit
Operation of
1
Unit
Wall mounting
1 of the remote
control
Wall mounting
4
of indoor unit
Wall mounting
of remote
control bracket
Outdoor unit
1
water drain
Padding of
outdoor unit
4
bottom support
Securing wires
4 in the indoor and
outdoor unit
Securing of
grounding wire
1
on the indoor
and outdoor unit
Transmitting
1
signals
Cleaning the air
2
Users and
1
installers
reference
CONTENT
I N S T R U C T I O N S
2
LOCATION OF INDOOR AND
OUTDOOR UNITS
Select the location considering the following:
INOOR UNIT
1. Choose a location which will provide good air circulation.
ensure that no objects or furnishings prevent air circulation.
2. Do not install the unit near a heat source or where it will be
exposed to direct sunlight.
3. The location must allow convenient electrical draingage and
tubing connections.
4. Installation site should provide an easy passage to outdoors.
5. The unit must be mounted on a strong wall that will withstand
the generated vibrations.
6. Install the mounting plate as shown.
OUTDOOR UNIT
1. The location must allow easy servicing and provide good air
circulation.
2. The unit may be suspended from a wall by a bracket
(Optional) or located in a free standing position on the floor
(preferably slightly elevated).
3. if the unit is suspended, ensure that the bracket is firmly
connected and the wall is strong enough to withstand
vibrations.
4. Unit location should not disturb neighbors with noise or
exhaust air stream.
5. Place the mounting pads under the unit legs.
6. Install the outdoor unit as shown. Refer to the technical and
service manual for allowed distances.
7. When the unit is installed on a wall, install the drain
connector hose and drain plug as shown.
Fig.1
1. Bottom of outdoor unit
2. Drain connector
Fig 1
1
2
Fig.2
Drain installation
Example
Fig 2