Air Direction Operation; Turning Off The Air Conditioner; On-Unit Operation; Current Clock Time Set - Electra WNG 7 Service Manual

I
J
F/A-PWR
K
COOL
RESET
HEAT
MODE
L
ESF-EN
M
N

AIR DIRECTION OPERATION

1.Air Direction Positioning
Press button (8) to position the air flap to any desired angle.
2.Automatic Vertical Air Swing
Press button (9) to activate the auto air swing. Press button (8)
to deactivate this function.

TURNING OFF THE AIR CONDITIONER

Press START/STOP button (1) to turn off the air conditioner. Indicator (A) on
the air cinditioner will be shifted from blue to red, indicating that
the air cinditioner is in STAND-BY mode and ready to accept any new
command from the remote control The remote control LCD will display the
clock time. The last operating set-up will be kept for the next ooperation.

ON-UNIT OPERATION

If the air-conditioner cannot be operated by the Remote Control unit,it can be
turned on for cooling or heating,or completely turned off,by pressing MODE
button (M) on the air-conditioner.The MODE button will change the operating
status of the unit between-COOLING-HEATING-STAND-BY positions,
every time it is pressed.Indicators (J) (L) or (G) will light up respectively,to
indicate in which mode the air-conditioner operates.
On units for Cooling only,do not set MODE switch on HEAT positon.

CURRENT CLOCK TIME SET

Clock setting is performed when batteries are inserted. The
remote control displays the setting and the clock display will
blink 0:00 or 12:00 AM(AM sign will blink, too) till a
new time is set.
For clock setting, use buttons (5) and (6) for setting the hours and minutes,
respectively, and then press timer SET button (12). The clock setting can be
also performed by pressing CLOCK button (19) for 5 seconds.
The clock display will blink, for new setting follow the steps describedabove.
LOCK FUNCTION
By pressing SPEED button (4) and SLEEP button (7) at the sane time. The
remote control will lock the last operation program. All the function buttons will
be inoperative, including START/STOP button. By pressing the two button
again the remote control will be released from its locked position. When lock
mode is functioning, the transmission sign (20) will be on.
CONTENT
11