Auto Cooling/Heating Operation; Dry Operation; Selecting The Temperature; I Feel Function - Electra WNG 7 Service Manual

AUTO COOLING/HEATING OPERATION

Select the AUTO mode by pressing MODE button (2). Switch to the desired
FAN SPEED or to AUTO FAN by pressing button (4). Select suitable
temperature setting. The air flap will automatically move to either horizontal
air delivery for cooling or to vertical air delivery for heating. At start, the air
conditioner will select its mode of operation according to the room
temperature and the temperature setting.

DRY OPERATION

Select the DRY mode by pressing MODE button (2). Select the suitable
temperature setting. While in DRY mode, the air conditioner will operate at low
fan speed, regardless of the fan setting on the LCD operation display. Fan
might terminate operation from time to time to prevent from over cooling.

SELECTING THE TEMPERATURE

Press TEMP button (5) or (6) to change the temperature setting in the LCD
operation display(13).The temperature setting is shown in degrees centigrade.
A higher number indicates a higher room temperature. A lower number indicates
a lower room temperature.

I FEEL FUNCTION

Press I FEEL button (3) to activate the I FEEL function. Thermometer sign will
appear on the LCD operation display (13). Select suitable temperature setting.
Make sure that the remote control unit is aimed at the air conditioner, with the
I FEEL sensor (14) in front. Prevent the I FEEL sensor from being affected by
heat sources such as lamps, heaters, direct sun, etc. or from being directly
affected by the air conditioner air flow. These may cause the sensor to transmit
the wrong temperature data, thereby disturbing the performance of the I FEEL
function.
SLEEP FUNCTION
Press the SLEEP button (7) to select the SLEEP function. When the sleep
function is activated the air conditioner will be automatically turned OFF after
seven hours. If at the same time TIMER is activated, as well ,the air conditioner
will be turned ON and OFF according to the TIMER setting.
To cancel the SLEEP function press on one of the following:
START/STOP button (1)
SLEEP button (7)
CONTENT
9