Timer Operation; Timer Operating Modes; Room Temperature; Timer On - Electra WNG 7 Service Manual

TIMER OPERATION

Press TIMER select button (11) to activate the timed operation mode. Each time you press
TIMER button (11), one of the following four operation modes will appear on the LCD
disp lay. The operation modes are sequenced in turn in the direction of arrow. During Timer
operation, the indicator on the air conditioner will light up.
Note: After the power is off (when the air-conditioner is in Timer mode), the air conditioner
will automatically switch to stand-by mode and the Timer operation will also be cancelled.
To resume the Timer operation, please follow the above instructions.

TIMER OPERATING MODES

I. TIMER ON
This mode enables you to set a start time .
Press Timer button (11) till ON sign blinks.
Star time can be adjusted using up and down
buttons (5) and (6) respectively. Press Set
button (12) to activate the timer.
Example: Operation is restored at 10:30 a.m.
IV. CLEAR
Use this mode to cancel timer operation. Press
TIMER button (11), timer operation will terminate
and the LCD display will be cleared for each
timer mode.
Note: If timer button (11) is selected and neither
time adjust, Set, or Clear buttons are not pressed
within 15 seconds; the timer operation will be
cancelled and the last setup will be displayed

ROOM TEMPERATURE

By pressing on ROOM temperature, button (16), the measured room
temperature and the room temperature sign will be displayed.
To cancel the ROOM Temperature display press on one of the following:
Press again on ROOM temperature button (16).
Change of MODE button (2)
Note: Room temperature range is between 0
Display should show "HI" or "LOW" to represent temperature that is above
36 or below 2 .
10
AM AM
PM
AM
PM
DISPLAY
II. TIMER OFF
This mode enables you to set the stop time of
operation. Press the Timer button (11) till the OFF
sign blinks. Time can be adjusted using up and
down buttons (5) and (6) respectively. Press Set
button (12) to activate the timer.
Example: Operation stops at 12:00 p.m. (24:00
hours).
III. TIMER ON/OFF
This mode enables you to set the start and
stop time of operation. Press Timer button
(11) till the OFF sign blinks. By press again
the ON sign blinks. Time
by using the up and down buttons (5) and
(6) respectively. Press Set button (12) to
activate the timer.
Example: Operation is restored at 10:30 a.m.
Operation stops at 12:00 p.m. (24:00 hours).
and 36 in 1 increments.
CONTENT
AM
PM PM
AM AM
PM PM
can be adjusted