CONTROL SYSTEM
12A.6.
Heating Mode
112Α.6.1. Heating Mode - General
•
Compensation Procedure:
The compensation procedure comes to solve the problem of the temperature
distribution by height during heat mode according to this procedure.
•
When I feel is OFF during heat mode: RT= RAT – CTV.
When I feel is ON during heat mode: RT= RCT.
•
CTV is a compensation temperature value to be used from the following table (CTV
table).
•
RCV is a reference compensation value (relation between cells).
•
IOC is a compensation value when IFAN is OFF.
•
The values of RCV and IOC to be set in the following table are taken from the RCV
and IOC table below depending on the model.
CTV table:
I
ICT
40 > ICT
50 > ICT ≥ 40
ICT ≥ 50
RCV and IOC table
•
The following table includes the RCV and IOC default values. These values are
set as values in the above compensation table.
WNG-30
WNG-28
WNG-25
No compensation will be activated in Forced operation modes.
12a-12
IFAN
OFF
IIOC
IIOC
IIOC+1
Model
Revision Y05-03
CONTENT
LOW
MEDIUM
RRCV+0
RRCV+0
RRCV+0
RRCV+0
RRCV+1
RRCV+1
RCV
o
+2
C
o
+2
C
o
+2
C
HIGH
RRCV+0
RRCV+0
RRCV+1
IOC
o
+2
C
o
+2
C
o
+2
C
Service Manual - WNG