Konica Minolta bizhub pro C6500P User Manual page 418

3
4
Load the desired size of paper to be adjusted on a tray, select
Fold&Staple and then press [Start] on the control panel.
A sample pattern (No. 16) will be output.
5
Check the misalignment center fold and position of staples on output
sheets.
6
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Fold & Staple Stopper Adjustment Screen will be restored.
7
Display the required size key using up/down arrow keys, and touch it.
8
Touch [+ <-> -] to specify the value to be positive or negative. Use the
touch panel keypad to enter the desired adjustment value, then touch
[<<SET].
Available range: -128 (wide) to +127 (narrow), 1 step = 1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is
obtained.
3-96
a a
Adjustment
bizhub PRO C6500P