Configuring The Network; Basic Setup; Network Service (Spa122 Only) - Cisco SPA112 Administration Manual

Configuring the Network

Basic Setup

Cisco SPA100 Series Administration Guide
This chapter describes how to configure the network settings for your ATA. It
includes the following sections:
• Basic Setup
• Advanced Settings
• Application (SPA122 Only)
Use the Network Setup > Basic Setup pages to configure your Internet
connection, local network settings (SPA122 only), and your time settings.
•

Network Service (SPA122 Only)

• Internet Settings
• Network Settings for the LAN and DHCP Server (SPA122 Only)
• Time Settings
Network Service (SPA122 Only)
Use the Network Setup > Basic Setup > Network Service page to configure the
operating mode of the SPA122.
After making changes, click Submit to save your settings, or click Cancel to
redisplay the page with the saved settings.
You can configure the ATA to operate in one of the following modes:
• NAT: Network Address Translation (NAT) is a function that allows multiple
devices on a private network to share a public, routable IP address to
establish connections over the Internet. To enable Voice over IP service to
3
25