Cisco SPA112 Administration Manual page 68

Configuring the Voice Settings
Regional
NOTE
Cisco SPA100Series Administration Guide
Defining Ring and Cadence and Tone Scripts
To define ring and tone patterns, the ATA uses the concept of scripts. Below is
information about creating Cadence Scripts (CadScripts), Frequency Scripts
(FreqScripts), and Tone Scripts (ToneScripts).
Total tone length is not configurable.
CadScript
A mini-script of up to 127 characters that specifies the cadence parameters of a
signal.
Syntax: S [;S ], where:
1 2
S =D (on ,1/off ,1[,on ,
i i i i i 2
known as a section, on
and i = 1 or 2, and j = 1 to 6. D
durations can have up to three decimal places to provide 1 ms resolution. The
wildcard character "*" represents infinite duration. The segments within a section
are played in order and repeated until the total duration is played.
Example 1: 60(2/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60 s
Number of Segments = 1
Segment 1: On=2s, Off=4s
Total Ring Length = 60s
Example 2—Distinctive ring (short,short,short,long): 60(.2/.2,.2/.2,.2/.2,1/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60s
Number of Segments = 4
Segment 1: On=0.2s, Off=0.2s
Segment 2: On=0.2s, Off=0.2s
Segment 3: On=0.2s, Off=0.2s
Segment 4: On=1.0s, Off=4.0s
Total Ring Length = 60s
/off , [,on /off , [,on ,
i 2 i,3 i 3 i 4
and off are the on/off duration in seconds of a segment
i,j i,j
is the total duration of the section in seconds. All
i
/off , [,on , /off , ,on ,
i 4 i 5 i 5 i 6
4
/off ]]]]]) and is
i,6
67