Cisco SPA112 Administration Manual page 64

Configuring the Voice Settings
Provisioning
Cisco SPA100Series Administration Guide
Field
Forced Resync
Delay
Resync From SIP
Resync After
Upgrade Attempt
Resync Trigger 1
Resync Trigger 2
Resync Fails On
FNF
Profile Rule
Description
Maximum delay (in seconds) that the ATA waits before
performing a resync.
The ATA does not resync while one of its lines is active.
Because a resync can take several seconds, it is desirable
to wait until the ATA has been idle for an extended period
before resynchronizing. This allows a user to make calls in
succession without interruption.
The ATA has a timer that begins counting down when all of
its lines become idle. This parameter is the initial value of
the counter. Resync events are delayed until this counter
decrements to zero.
Default setting: 14400 seconds
Enables a resync to be triggered via a SIP NOTIFY
message.
Default setting: yes
Triggers a resync after every firmware upgrade attempt.
Default setting: yes
Configurable resync trigger conditions. A resync is
triggered when the logic equation in these parameters
evaluates to TRUE.
Default setting: blank
Determines whether a file-not-found response from the
provisioning server constitutes a successful or a failed
resync. A failed resync activates the error resync timer.
Default setting: yes
This parameter is a profile script that evaluates to the
provisioning resync command. The command is a TCP/IP
operation and an associated URL. The TCP/IP operation
can be TFTP, HTTP, or HTTPS.
If the command is not specified, TFTP is assumed, and the
address of the TFTP server is obtained through DHCP
option 66. In the URL, either the IP address or the FQDN of
the server can be specified. The file name can have
macros, such as $MA, which expands to the ATA MAC
address.
Default setting: /spa$PSN.cfg
4
63