One Push Demo" Setting (Function Code 28) - Brother HL-3040CN Service Manual

1.4.7

"One Push Demo" setting (Function code 28)

<Function>
The One Push Demo function is to implement demo printing by pressing the Go button, which
is mainly used for sales promotion at the shop. It is disabled if printing from a computer even
once.
Therefore, it is necessary to change the setting so that the function is enabled again.
OnePushDemo = ON (Enabled) / OFF (Disabled)
The default setting is displayed with "*".
<Operating Procedure: How to set "OnePushDemo = ON">
(1) Press the
the maintenance mode. Then, press the OK button. The machine displays "One Push
Demo=ON" on the LCD.
(2) Press the OK button so that the One Push Demo function is set to be enabled.
(3) The machine automatically returns to the initial state of the maintenance mode.
Note:
- To terminate this operation, press the Cancel button. The machine returns to the initial
state of the maintenance mode.
- Once the One Push Demo function is enabled, printing from a computer does not disable
this function unless the power is turned OFF. (After the One Push Demo function is
enabled, if the power is turned OFF and ON again, and then printing is made from a
computer, the function is disabled.)
or button to display "MAINTENANCE 28" on the LCD in the initial state of
7-11
Confidential