Frame Pattern Print (Function Code 69) - Brother HL-3040CN Service Manual

1.4.13 Frame pattern print (Function code 69)

<Function>
This function allows you to print the external periphery frame pattern on a sheet and check if
there is print deflection and/or loss.
<Operating procedure>
(1) Load Letter-size paper on the paper tray.
(2) Press the
the maintenance mode. Then, press the OK button. "PRINTING" is displayed on the
LCD, and the frame pattern (see the figure below) is printed on a sheet.
When printing fails, a relevant error is displayed on the LCD. When the error factors are
removed and the Go button is pressed, the machine automatically recovers to the
re-executable state. When the OK button is pressed, "PRINTING" is displayed on the
LCD, and the frame pattern is printed on a sheet.
(3) Press the Cancel button to return to the machine to the initial state of the maintenance
mode.
When an error message is displayed on the LCD, take the measures described in the
table below.
Error message
TONER EMPTY # *
Cover is Open
No Paper
Jam Tray1
Jam Rear
* # indicates the toner color (K, Y, M, or C) of which cartridge became empty.
or button to display "MAINTENANCE 69" on the LCD in the initial state of
Replace the empty toner cartridge and press the Go button to
clear the error. Perform the frame pattern print again.
Close the top cover.
Replenish paper, and press the Go button to clear the error.
Remove the jammed paper, and press the Go button to clear
the error.
Remove the jammed paper, and press the Go button to clear
the error.
7-26
Measure
Confidential