Fuser/Eject Drive Motor Sensor Pcb Assy - Brother HL-3040CN Service Manual

8.45 Fuser/Eject Drive Motor Sensor PCB ASSY

(1) Remove the two Taptite bind B M4x12 screws, and then remove the Eject gear cover from
the Side frame L.
Side frame L
Note:
Be careful when changing the setup condition of the main body with the left side up while
the Eject gear cover is removed because the gear may fall off.
(2) Release the Hook to remove the Fuser/eject drive motor sensor PCB ASSY from the
Eject gear cover.
Harness routing: Refer to
Taptite bind B M4x12
2b
2a
Hook
" Fuser/Eject Drive Motor, Fuser/Eject Drive Motor Sensor PCB
ASSY."
Hook
Taptite bind B M4x12
Fig. 5-144
Fuser/eject drive motor sensor PCB ASSY
Eject gear cover
Fig. 5-145
5-115
Eject gear cover
Hook
Confidential