Error Messages - Brother HL-3040CN Service Manual

2.2

Error Messages

The error messages displayed on the LCD of the product and their description and measure
are shown in the table below.
Error message
Access Error
(HL-3070CW only)
Belt End Soon
Calibrate
Scroll message:
Calibration failed.
See
Troubleshooting
chapter in User's
guide.
Cartridge Error
Cover is Open
DIMM Error
Drum End Soon
(X) * Drums End
or
Soon
Drum Error
Fuser Error
Jam XXX
Low Temperature
Manual Feed
No Belt Unit
No Paper
No Toner
* (X) at the end of the message shows the color of the toner cartridge or drum unit.
(X) must be either K (Black), Y (Yellow), M (Magenta) or C (Cyan).
Description/ Measure
The USB device was removed while data was
processing. Press Cancel button. Reinsert the USB
device and try to print with Direct Print or PictBridge.
The belt unit is near the end of its life. Buy a new belt
unit before you get a "Replace Belt" message.
- Turn off the printer. Wait a few seconds and turn it on
again.
- Put in a new drum unit.
- Put in a new belt unit.
- Put in a new waste toner box.
Take out the drum unit and toner cartridge assembly for
the toner color that is indicated on the LCD. Remove the
toner cartridge and then re-install it in the drum. Put the
drum unit and toner cartridge assembly back into the
printer again.
Close the cover that is indicated on the LCD.
Turn off the printer. Re-install the DIMM correctly. Wait a
few seconds and turn it on again. If this error message
appears again, replace the DIMM with a new one.
The drum unit is near the end of its life. Buy a new drum
unit that is indicated on the LCD before you get a
"Replace Drum" message.
Clean the corona wires. If the LCD still shows the same
error message after you have cleaned the corona wire,
replace the drum unit with a new one that is indicated on
the LCD.
Turn off the power switch, wait a few seconds and then
turn it on again. Leave the printer for 15 minutes with the
power on.
Carefully pull out the jammed paper from the area shown
in the message.
Increase room temperature to allow the printer to operate.
Put the same size of paper in the manual feed slot as is shown
on the LCD. If the printer is "paused", press Go button.
Install the belt unit.
Put paper in the indicated empty tray. If the problem is
not solved, the paper pick-up roller may be stained.
Clean the paper pick-up roller.
Install the toner cartridge that is indicated on the LCD.
Install the drum unit that is indicated on the LCD.
3-8
Refer to:
3-43
3-26
3-30
3-34
3-50
3-41
3-24
3-36
3-40
3-43
3-23
3-13
3-31
3-25
3-45
3-35
3-36
3-52
---
3-39
3-44
3-39
3-40
3-49
Confidential