Address Switch Setting - Sanyo SPW-C0705DZH8 Technical Data Manual

4. System Controller

Address Switch Setting

Gap
Gap
Coin
To avoid an electric shock hazard,
DO NOT touch any terminal on the
WA R N I N G
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
hand when power is supplied.
Dip switches
How to reach the PCB
Remove the Machine screw on the bottom of the back case. When you
open up the decorative cover, you will see 2 notches under the control
unit. Inset a coin or other flat object into these notches and pry off the
back case. The PCB on the back of the control unit is now visible.
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
All bits are set off
when shipped from
factory.
PCB of the control unit
3-59
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8