Address Switch Setting - Sanyo MINI ECO-i XHX1252 Service Manual & Test Run Service Manual

4. System Controller (SHA-KC64UG)
Gap
Gap
Coin

2. Address switch setting

To avoid an electric shock hazard,
DO NOT touch any terminal on the
WA R N I N G
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
hand when power is supplied.
How to reach the P.C. board
Remove the cross flat head screw on the bottom of the back case. When
you open up the decorative cover, you will see two notches under the
control unit. Inset a coin or other flat object into these notches and pry off
the back case. The P.C. board on the back of the control unit is now visible.
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
All bits are set off
when shipped from
factory.
PCB of the control unit
2-50
Remote Control Functions