How To Reach The Pcb; I Address Switch Setting - Sanyo SPW-CR365GXH56 Technical Data Manual

4. System Controller

I Address Switch Setting

3
Gap
Gap
Coin
To avoid an electric shock hazard,
DO NOT touch any terminal on the
WA R N I N G
Printed Circuit Board with a metal
rod, a screwdriver edge or a bare
hand when power is supplied.
Dip switches

How to reach the PCB

Remove the flat-top screw on the bottom of the back case. When you
open up the decorative cover, you will see 2 notches under the control
unit. Inset a coin or other flat object into these notches and pry off the
back case. The
Control of Mini ECO-i SYSTEM
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
All bits are set off
when shipped from
factory.
PCB of the control unit
on the back of the control unit is now visible.
PCB
3 - 50