Maintenance; Address Setting Of The Remote Control Unit; Disconnecting And Connecting Positive Connector For Outdoor Unit - Sanyo SAP-KV94GJ Manual

8. MAINTENANCE

8-1. Address Setting of the Remote Control Unit

The address can be set in order to prevent interference between remote controllers when 2 Sanyo indoor
units are installed near each other. The address is normally set to "A." To set a different address, it is necessary
to change the address on the second remote controller. If 3 or more (up to 4) indoor units are installed, use
remote controllers that are intended for servicing use.
Remove the batteries from the second remote
NOTE
controller before changing the address.
(1) Break the address-setting tab marked "A" on the second
remote controller to change the address. (Fig. 8)
When the tab is removed, the address is automatically
set to B. (Fig. 9)
(2) Insert dry-cell batteries into the second remote
controller and press the ACL button. (Fig. 9) Then
reattach the cover.
(3) Open the air intake grille on the second indoor unit.
Move the operation switch to the "DEMO" position.
(Fig. 10)
(4) Press the ON/OFF operation button on the remote
controller. Check that the "beep" signal-received sound
is heard from the second indoor unit. (Fig. 10)
(5) Move the operation selector switch to the "ON" position,
and close the intake grille.
(6) Operate the remote controller. Check that the "beep"
signal-received sound is heard from the second indoor
unit.

8-2. Disconnecting and Connecting Positive Connector for Outdoor Unit

When the cover is pulled upward, the lock is
released with the sequence of 1 and 2.
Pull cover upward
One of the two types of connectors illustrated at left is used. Their
basic structure is the same for each.
How to disconnect
Hold the resin connector cover, and pull the connector off.
You cannot disconnect the connector by pulling the wire since
it is locked inside. Always hold the cover to disconnect. (See
illustration at left.) For the connector without the resin cover,
push the lock in the direction of "2" while pulling it off.
How to connect
In order to connect, hold the resin cover of the connector and
push it in. Confirm the click sound for the inside lock.
24
Tab
Fig. 8
ACL button
Fig. 9
Operation selector switch
DEMO.
TEST
ON
OFF
Fig. 10