Wiring The Receiver; Wiring Diagram - Sanyo SPW-C0705DZH8 Technical Data Manual

2. Wireless Remote Controller
Unidirectional cassette model for high ceilings/Unidirectional ceiling cassette model
1 While spreading the tabs of the cover, pull it out from the panel to the front. (Fig. 3-10)
2 Pass the lead wire through the panel and install the receiver in the hole in the panel. (The projecting parts of the receiver hold
it in the hole in the panel)
3 Press the lead wire from the receiver in along the rib on the back of the panel. If installing to a unidirectional high ceiling
cassette, pass it through the cutout. (Fig. 3-11)
4 Install the panel on the indoor unit.
5 Fasten the lead wire sticking out from the panel with the clamp on the inside of the indoor unit. (Fig. 3-12)
6 Draw the lead wire into the electrical box through the hole on the bottom and connect it to the remote control terminal strip.
If installing to a high ceiling unidirectional cassette, fasten the wire at the latch of the fan casing with the enclosed cable tie.
(Fig. 3-13)
Pull off to the
front
Fig. 3-10
High ceiling unidirectional
cassette
NOTE
(1) If the wiring for the receiver is bundled with other wires, such as the incoming line, it may cause a malfunction, so avoid
putting them together.
(2)
Fasten the lead wire securely so it does not get wrapped up in the fan.
(3) If something causes the unit's power source to make noise it will be necessary to resolve the problem, such as by installing
a noise filter.
For more information about wiring or test operation, refer to Wiring the Receiver and Test Operation.

2-11. Wiring the Receiver

Wiring Diagram

Terminal Strip for
Wiring Remote
Controls
Connections
Connect the wires from the receiver to the remote control terminal strip on the indoor unit. (Polarity does not matter)
Spread
Cover
Press the
Spread
lead wire
in
Unidirectional ceiling
cassette
Clamp
Fig.3-12
Indoor Unit
2 White
3
Black
High ceiling unidirectional
cassette
(Back of
the panel)
Receiver
Rib
Cutout
Fan Casing
Receiver PCB
CN001
2RWhite
3-17
Control of 3-WAY ECO-i SYSTEM
Unidirectional ceiling
cassette
Receiver
Press the
Rib
lead wire
in
Fig. 3-11
Fasten at the
latch of the
fan casing
with enclosed
clamp.
Fig.3-13
1
2
3
4
5
6
7
8