Test Run Setting - Sanyo SPW-C0705DZH8 Technical Data Manual

6. Simplifi ed Remote Controller

Test run setting

1. Press both and
and then press
• "TEST" will appear on the display during test run.
• During test run, temperature cannot be adjusted. This button should be used only for test run.
2. Perform test run in any operation mode of "heat", "cool" or "fan".
N O TE
The outdoor unit does not operate for 3 minutes after stopping operation or turning on the unit.
3. After test run is finished, press both
and then make sure "TEST" goes off from the display. (The 60-minute off timer function is provided
for this remote controller in order to avoid continuous test run.)
Caution
Caution when installing the remote controller (See Fig. 3-72-1)
*1 Install the remote controller more than 70 mm apart from the corner of the wall.
(See Fig. 3-72-2)
*2 To install the remote controllers side-by-side, keep the space between each for more than 75 mm.
(See Fig. 3-72-2)
1
*3 To install the remote controllers one above the other, keep the space between each for more than 25 mm.
(See Fig. 3-72-3)
2
17
3
4
5
6
7
8
buttons on the remote controller for more than 4 seconds together,
(ON/OFF) button.
and
70
(*1) (*2)
Fig. 3-72-2
buttons again for more than 4 seconds together,
66.8
10
9.4
9.4
13
33.4
Fig. 3-72-1
3-102
Control of 3-WAY ECO-i SYSTEM
Unit: mm
(*3)
Fig. 3-72-3