Sequence; Adding A New Sequence; Configuring A New Sequence - Digimerge DHU600 Series Instruction Manual

Using the System Menu
channel to display on-screen when an
alarm is triggered
• ALARM POP-UP DWELL: Set the time (in
seconds) for the associated channel to
remain on-screen when an alarm is
triggered; select from 1 sec, 2 sec, 3 sec, 5
sec (default), 10 sec, 15 sec, 20 sec, 30 sec,
40 sec, or 60 sec
• MOTION POP-UP MODE: Select ON/OFF to
enable/disable the associated channel to
appear in full-screen when motion is
triggered
• MOTION POP-UP DWELL: Set the time (in
seconds) for the associated channel to
remain in full-screen when motion is
triggered; select from 1 sec, 2 sec, 3 sec, 5
sec (default), 10 sec, 15 sec, 20 sec, 30 sec,
40 sec, or 60 sec
• CIF PLAYBACK SCALER: Select ON or OFF.
3. Select APPLY and press ENTER to save
your settings or select CANCEL to restore
defaults.
4. Select CLOSE and press ENTER to exit.

SEQUENCE

Use the Sequence menu to define a custom
sequence, using mixed multi screen views and
any desired channels.

Adding a New Sequence

Create a new sequence for Auto Sequence
mode.
You can create up to 16 sequences.
NOTE:
Figure 18.2 Sequence menu
To add a new sequence:
1. Select SEQUENCE and press ENTER.
34
2. Select ADD and press ENTER. The Add
window opens.
Figure 18.3 Add window
3. Select SEQUENCE TITLE and press ENTER
to open the Virtual Keyboard and enter a
name for the sequence. Select OK and
press ENTER.
4. Select ACTIVATION and press ENTER;
select ON to enable the new sequence.
5. Select SAVE and press ENTER. The
Sequence window opens:
Figure 18.4 Sequence window (blank)
6. Select ADD and press ENTER. The
Sequence Setup window opens

Configuring a New Sequence

With the new sequence added, you can now set
on-screen configurations and channels for the
sequence.
Figure 18.5 Sequence Setup