Turn Signals; Lane Change Assist; Flash-To-Pass; High/Low Beam Switch - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 112 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 3AA39145
/chry_pdm/chrysler/owners/grc/og
art=031509530.tif

Turn Signals

Move the multifunction lever up or down and
the arrows on each side of the instrument
cluster flash to show proper operation of the
front and rear turn signal lights.
NOTE:
If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it
would suggest that the indicator bulb is
defective.
110
NO TRANS
Multifunction Lever

Lane Change Assist

Tap the lever up or down once, without moving
beyond the detent, and the turn signal (right or
left) will flash three times then automatically turn
off.

Flash-To-Pass

You can signal another vehicle with your head-
lights by partially pulling the multifunction lever
toward the steering wheel. This will cause the
high beam headlights to turn on until the lever
is released.

High/Low Beam Switch

Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beam. Pulling the multifunction back toward the
steering wheel will turn the low beams back on,
or shut the high beams off.
WINDSHIELD WIPERS AND
WASHERS
The windshield wiper/washer control lever is
located on the left side of the steering column.
The front wipers are operated by rotating a
switch, located on the end of the lever. For
information on the rear wiper/washer, refer to
"Rear Window Features" in "Understanding the
Features of Your Vehicle".
art=031509530.tif NO TRANS
Windshield Wiper/Washer Switch

Windshield Wiper Operation

Rotate the end of the lever to one of the first four
detent positions for intermittent settings, the
fifth detent for low wiper operation and the sixth
detent for high wiper operation.