Jeep Grand Cherokee WK2 Owner's Manual page 256

JOBNAME: CHRY OM INTL (Conten PAGE: 256 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 3F369D74
/chry_pdm/chrysler/owners/grc/og
Shifting Into NEUTRAL (N)
WARNING!
You or others could be injured if you leave the
vehicle unattended with the transfer case in
the NEUTRAL (N) position without first fully
engaging the parking brake. The transfer case
NEUTRAL (N) position disengages both the
front and rear driveshafts from the powertrain
and will allow the vehicle to move, even if the
transmission is in PARK. The parking brake
should always be applied when the driver is
not in the vehicle.
Use the following procedure to prepare your
vehicle for recreational towing.
CAUTION!
It is necessary to follow these steps to be
certain that the transfer case is fully in NEU-
TRAL (N) before recreational towing to pre-
vent damage to internal parts.
1. Bring the vehicle to a complete stop and
shift the transmission to PARK.
254
2. Turn OFF the ignition.
3. For vehicles with Keyless Enter-N-Go, re-
move the Keyless Enter-N-Go button and use
the key fob to complete this procedure. Refer to
"Starting Procedures/Keyless Enter-N-Go" in
"Starting and Operating" for further information.
4. Turn the ignition switch to the ON/RUN po-
sition, but do not start the engine.
5. Press and hold the brake pedal.
6. Shift the transmission into NEUTRAL.
7. Using the point of a ballpoint pen or similar
object, press and hold the recessed transfer
case N (Neutral) button (located by the selector
switch) for four seconds, until the light behind
the N symbol starts to blink, indicating shift in
progress. The light will stop blinking (stay on
solid) when the shift to N (Neutral) is complete.
A "FOUR WHEEL DRIVE SYSTEM IN NEU-
TRAL" message will display on the EVIC (Elec-
tronic Vehicle Information Center). Refer to
"Electronic Vehicle Information Center (EVIC)"
in "Understanding Your Instrument Panel" for
further information.
art=051810686.tif NO TRANS
Neutral Switch
8. Start the engine.
9. Shift the transmission into REVERSE.
10. Release the brake pedal for five seconds
and ensure that there is no vehicle movement.
11. Turn OFF the engine and leave the ignition
switch in the unlocked OFF position.
12. Firmly apply the parking brake.
13. Shift the transmission into PARK.