Jeep Grand Cherokee WK2 Owner's Manual page 53

JOBNAME: CHRY OM INTL (Conten PAGE: 53 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 5630B0D4
/chry_pdm/chrysler/owners/grc/og
WARNING!
Do not use the cargo tie downs located on the
load floor. Improper usage of the tether can
lead to a failure of an infant or child restraint.
The child could be badly injured or killed.
Many, but not all restraint systems will be
equipped with separate straps on each side,
with each having a hook or connector for
attachment to the lower anchorage and a
means of adjusting the tension in the strap.
Forward-facing toddler restraints and some
rear-facing infant restraints will also be
equipped with a tether strap, a hook for attach-
ment to the tether strap anchorage and a
means of adjusting the tension of the strap.
First, loosen the child seat adjusters on the
lower straps and on the tether strap so that you
can more easily attach the hooks or connectors
to the vehicle anchorages. Next, attach the
lower hooks or connectors over the top of the
anchorage bars, pushing aside the seat cover
material. Then, locate the tether anchorage
directly behind the seat where you are placing
the child restraint and attach the tether strap to
the anchorage, being careful to route the tether
strap to provide the most direct path between
the anchor and the child restraint. There are
two top tether anchorages located on the
back of the seat, behind the gap panel. They
are not visible until you fold the gap panel
down. Do not use the cargo tie down hooks
located on the floor behind the seat. Finally,
tighten both straps as you push the child
restraint rearward and downward into the seat,
removing slack in the straps according to the
child restraint manufacturer's instructions.
WARNING!
Improper installation of a child restraint to the
ISOFIX anchorages can lead to failure of an
infant or child restraint. The child could be
badly injured or killed. Follow the manufactur-
er's directions exactly when installing an in-
fant or child restraint.
Installing Child Restraints Using the
Vehicle Seat Belts
The passenger seat belts are equipped with
either cinching latch plates or Automatic Lock-
ing Retractors (ALR), which are designed to
keep the lap portion tight around the child
restraint so that it is not necessary to use a
locking clip. If the seat belt has a cinching latch
plate, pulling up on the shoulder portion of the
lap/shoulder belt will tighten the belt. The
cinching latch plate will keep the belt tight;
however, any seat belt system will loosen with
time, so check the belt occasionally and pull it
tight if necessary.
For seat belts having an Automatic Locking
Retractor (ALR), pull the belt from the retractor
until there is enough allowance to pass it
through the child restraint and slide the latch
plate into the buckle. Then, pull the belt until it
is fully extended from the retractor. Allow the
belt to return into the retractor, pulling on the
excess webbing to tighten the lap portion
around the child restraint. Refer to "Automatic
Locking Mode".
To attach a child restraint tether strap:
For rearward facing infant seats secured in the
center seat position with the vehicle seat belts,
the rear center seat position has an armrest
tether that secures the arm rest in the upward
position. To access the center seat arm rest
51