Table of Contents
Advertisement
JOBNAME: CHRY OM INTL (Conten PAGE: 97 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 43A70B69
/chry_pdm/chrysler/owners/grc/og
Front Passenger Seat Fold-Flat
Feature — If Equipped
To fold the seatback to the flat load-floor posi-
tion, lift the recline lever and push the seatback
forward. To return to the seating position, raise
the seatback and lock it into place.
art=030933466.tif
NO TRANS
Fold-Flat Passenger Seat
Heated Seats — If Equipped
On some models, the front and rear seats may
be equipped with heaters in both the seat
cushions and seatbacks.
WARNING!
• Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medi-
cation, alcohol use, exhaustion or other
physical condition must exercise care when
using the seat heater. It may cause burns
even at low temperatures, especially if
used for long periods of time.
• Do not place anything on the seat that
insulates against heat, such as a blanket or
cushion. This may cause the seat heater to
overheat. Sitting in a seat that has been
overheated could cause serious burns due
to the increased surface temperature of the
seat.
CAUTION!
Repeated overheating of the seat could dam-
age the heating element and/or degrade the
material of the seat.
Vehicles Equipped with Remote Start
On models that are equipped with remote start,
the driver's heated seat can be programmed to
come on during a remote start. Refer to "Re-
mote Starting System — If Equipped" in
"Things to Know Before Starting Your Vehicle"
for further information.
Front Heated Seats
There are two heated seat switches that allow
the driver and passenger to operate the seats
independently. The controls for each heater are
located near the bottom center of the instru-
ment panel (below the climate controls).
You can choose from HIGH, LOW or OFF heat
settings. Amber indicator lights in each switch
indicate the level of heat in use. Two indicator
lights will illuminate for HIGH, one for LOW and
none for OFF.
art=030902460.tif
NO TRANS
Press the switch once to select
HIGH-level heating. Press the
switch a second time to select
LOW-level heating. Press the
switch a third time to shut the heat-
ing elements OFF.
95
Advertisement
Chapters
Table of Contents
