Table of Contents
Advertisement
50
GETTING TO KNOW YOUR VEHICLE
•
Broken, muddy, or obstructed headlights and tail-
lights of vehicles in the field of view will cause head-
lights to remain on longer (closer to the vehicle).
Also, dirt, film, and other obstructions on the wind-
shield or camera lens will cause the system to func-
tion improperly.
FLASH-TO-PASS
The Flash-To-Pass feature will illuminate the high beam
headlights temporarily to signal another vehicle of a
passing occurrence. Pull and hold the Multifunction
Lever to activate the Flash-To-Pass feature. When the
lever is released, the Flash-To-Pass feature will
deactivate.
AUTOMATIC HEADLIGHTS —
IF EQUIPPED
The Automatic Headlight System will turn the headlights
on or off according to ambient light levels. To turn the
system on, rotate the headlight switch clockwise to the
last detent for automatic headlight operation. When the
system is on, the headlight time delay feature is also
on. This means the headlights will stay on for up to
90 seconds (programmable through the Uconnect Set-
page 166) after you place the ignition into the
tings
OFF position. To turn the automatic system off, move
the headlight switch out of the AUTO position.
NOTE:
The engine must be running before the headlights will
come on in the automatic mode.
LIGHTS-ON REMINDER
If the headlights or parking lights are left on after the
ignition is placed in the OFF position, the vehicle will
chime when the driver's door is opened.
FRONT FOG LIGHTS — IF EQUIPPED
The Front Fog Lights are located on the front of the
vehicle below the headlights. When activated, these
lights add illumination directed at the driving surface to
aid in poor visibility conditions.
To activate the Front Fog Lights, turn on the parking
lights or low beam headlights and push the fog light
switch. Pushing the fog light switch a second time will
turn the front fog lights off.
Front Fog Light Switch
Front Fog Light Switch (Vehicles Sold In Canada)
TURN SIGNALS
Move the multifunction lever up or down to activate the
turn signals. The arrows on each side of the instrument
cluster flash to show proper operation.
NOTE:
If either light remains on and does not flash, or there is
a very fast flash rate, check for a defective outside light
bulb.
LANE CHANGE ASSIST —
IF EQUIPPED
Lightly push the multifunction lever up or down, without
moving beyond the detent, and the turn signal will flash
three times then automatically turn off.
Advertisement
Table of Contents
