Uconnect™ Phone Features - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 81 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 4A6A60E4
/chry_pdm/chrysler/owners/grc/og
second phone call, as described under "Mak-
ing a Second Call While Current Call in
Progress". After the second call has estab-
lished, press and hold the
hear a double beep, indicating that the two
calls have been joined into one conference call.
Call Termination
To end a call in progress, momentarily press
the button. Only the active call(s) will be
terminated and if there is a call on hold, it will
become the new active call. If the active call is
terminated by the phone far end, a call on hold
may not become active automatically. This is
cell phone-dependent. To bring the call back
from hold, press and hold the
you hear a single beep.
Redial
• Press the
button to begin.
• After the "Ready" prompt and the following
beep, say "Redial".
• The Uconnect™ Phone will call the last num-
ber that was dialed from your mobile phone.
NOTE:
This may not be the last number dialed from
the Uconnect™ Phone.
button until you
Call Continuation
Call continuation is the progression of a phone
call on the Uconnect™ Phone after the vehicle
ignition key has been switched to OFF. Call
continuation functionality available on the ve-
hicle can be any one of three types:
• After the ignition key is switched to OFF, a
call can continue on the Uconnect™ Phone
either until the call ends, or until a vehicle
specific time expires, or until the vehicle
battery condition dictates cessation of the
button until
call on the Uconnect™ Phone and transfer of
the call to the mobile phone.
• After the ignition key is switched to OFF, a
call can continue on the Uconnect™ Phone
for a certain duration, after which the call is
automatically
Uconnect™ Phone to the mobile phone.
• An active call is automatically transferred to
the mobile phone after the ignition key is
switched to OFF.
Uconnect™ Phone Features
Language Selection
To change the language that the Uconnect™
Phone is using:
• Press the
• After the "Ready" prompt and the following
• Continue to follow the system prompts to
After selecting one of the languages, all
prompts and voice commands will be in that
language.
NOTE:
After every Uconnect™ Phone language
change operation, only the language-
specific 32-name phonebook is usable. The
transferred from the
paired phone name is not language-specific
and usable across all languages.
For command translations and alternate com-
mands in supported languages, refer to "Com-
mand Translations".
button to begin.
beep, say the name of the language you
wish to switch to (English, Dutch, French,
German, Italian, or Spanish, if so equipped).
complete language selection.
79