Rear Cross Path - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 72 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 2F60A86E
/chry_pdm/chrysler/owners/grc/og
The BSM system is designed not to issue an
alert on stationary objects such as guardrails,
posts, walls, foliage, berms, etc. However, oc-
casionally the system may alert on such ob-
jects. This is normal operation and your vehicle
does not require service.
art=030405239.tif
The BSM system will not alert you of objects
that are traveling in the opposite direction of the
vehicle in adjacent lanes.
70
NO TRANS
Stationary Objects
art=030405541.tif NO TRANS
Opposing Traffic
WARNING!
The Blind Spot Monitoring system is only an
aid to help detect objects in the blind spot
zones. The BSM system is not designed to
detect pedestrians, bicyclists, or animals.
Even if your vehicle is equipped with the BSM
system, always check your vehicles mirrors,
glance over your shoulder, and use your turn
signal before changing lanes. Failure to do so
can result in serious injury or death.

Rear Cross Path

The Rear Cross Path (RCP) feature is intended
to aid the driver when backing out of parking
spaces where their vision of oncoming vehicles
may be blocked. Proceed slowly and cau-
tiously out of the parking space until the rear
end of the vehicle is exposed. The RCP system
will then have a clear view of the cross traffic
and if an oncoming vehicle is detected, alert
the driver.
art=030405522.tif NO TRANS
RCP Detection Zones
RCP monitors the rear detection zones on both
sides of the vehicle, for objects that are moving
toward the side of the vehicle with a minimum
speed of approximately 1 to 2 mph (1 km/h to