Extreme Cold Weather (Below 20°F Or 29°C); If Engine Fails To Start; After Starting - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 204 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 52D03A88
/chry_pdm/chrysler/owners/grc/og
• Press the ENGINE START/STOP button a
second time to change the ignition switch to
the RUN position (EVIC displays "IGNITION
MODE RUN"),
• Press the ENGINE START/STOP button a
third time to return the ignition switch to the
OFF position (EVIC displays "IGNITION
MODE OFF").
Extreme Cold Weather (Below
or 29°C)
To ensure reliable starting at these tempera-
tures, use of an externally powered electric
engine block heater (available from your autho-
rized dealer) is recommended.

If Engine Fails To Start

WARNING!
• Never pour fuel or other flammable liquids
into the throttle body air inlet opening in an
attempt to start the vehicle. This could
result in a flash fire causing serious per-
sonal injury.
202
WARNING! (Continued)
• Do not attempt to push or tow your vehicle
to get it started. Vehicles equipped with an
automatic transmission cannot be started
this way. Unburned fuel could enter the
catalytic converter and once the engine has
started, ignite and damage the converter
and vehicle. If the vehicle has a discharged
20°F
battery, booster cables may be used to
obtain a start from a booster battery or the
battery in another vehicle. This type of start
can be dangerous if done improperly. Refer
to "Jump Starting" in "What To Do In Emer-
gencies" for further information.
Clearing a Flooded Engine (Using ENGINE
START/STOP Button)
If the engine fails to start after you have fol-
lowed the "Normal Starting" or "Extreme Cold
Weather procedures, it may be flooded. To
clear any excess fuel, press and hold the brake
pedal, push the accelerator pedal all the way to
the floor and hold it, then press and release the
(Continued) ENGINE START/STOP button once. The starter
motor will engage automatically, run for 10 sec-
onds, and then disengage. Once this occurs,
release the accelerator pedal and the brake
pedal, wait 10 to 15 seconds, then repeat the
"Normal Starting" procedure.
Clearing A Flooded Engine (Using Fob
With Integrated Key)
If the engine fails to start after you have fol-
lowed the "Normal Starting" or "Extreme Cold
Weather" procedures, it may be flooded. To
clear any excess fuel, push the accelerator
pedal all the way to the floor and hold it. Then,
turn the ignition switch to the START position
and release it as soon as the starter engages.
The starter motor will disengage automatically
in 10 seconds. Once this occurs, release the
accelerator pedal, turn the ignition switch to the
LOCK position, wait 10 to 15 seconds, then
repeat the "Normal Starting" procedure.
CAUTION!
To prevent damage to the starter, wait 10 to
15 seconds before trying again.

After Starting

The idle speed is controlled automatically and it
will decrease as the engine warms up.