Head Restraints - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 99 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 420100D1
/chry_pdm/chrysler/owners/grc/og
switches are located on the switch bank in the
center stack of the instrument panel, just below
the climate controls.
art=030905581.tif NO TRANS
The
switches are used to
control the speed of the
fans located in the seat.
Press the switch once
to choose HIGH, press
it a second time to
choose LOW. Pressing
the switch a third time
will turn the ventilated
seat OFF. When HIGH speed is selected both
lights on the switch will be illuminated. When
LOW speed is selected one light will be illumi-
nated.
NOTE:
The engine must be running for the venti-
lated seats to operate.
Vehicles Equipped with Remote Start
On models that are equipped with remote start,
the driver's ventilated seat can be programmed
to come on during a remote start. Refer to
"Remote Starting System — If Equipped" in
"Things to Know Before Starting Your Vehicle"
for further information.
ventilated seat

Head Restraints

Head restraints are designed to reduce the risk
of injury by restricting head movement in the
event of a rear-impact. Head restraints should
be adjusted so that the top of the head restraint
is located above the top of your ear.
WARNING!
The head restraints for all occupants must be
properly adjusted prior to operating the ve-
hicle or occupying a seat. Head restraints
should never be adjusted while the vehicle is
in motion. Driving a vehicle with the head
restraints improperly adjusted or removed
could cause serious injury or death in the
event of a collision.
Active Head Restraints — Front Seats
Active Head Restraints are passive, deployable
components, and vehicles with this equipment
cannot be readily identified by any markings,
only through visual inspection of the head re-
straint. The head restraint will be split in two
halves, with the front half being soft foam and
trim, the back half being decorative plastic.
When AHRs deploy during a rear impact, the
front half of the head restraint extends forward
to minimize the gap between the back of the
occupant's head and the AHR. This system is
designed to help prevent or reduce the extent
of injuries to the driver and front passenger in
certain types of rear impacts. Refer to "Occu-
pant Restraints" in "Things To Know Before
Starting Your Vehicle" for further information.
To raise the head restraint, pull upward on the
head restraint. To lower the head restraint,
press the push button, located at the base of
the head restraint, and push downward on the
head restraint.
97