Jeep Grand Cherokee WK2 Owner's Manual page 52

JOBNAME: CHRY OM INTL (Conten PAGE: 52 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 30787B77
/chry_pdm/chrysler/owners/grc/og
positions only. Regardless of the specific type
of lower attachment, never install ISOFIX-
compatible child seats such that two seats
share a common lower anchorage.
If you are installing ISOFIX-compatible child
restraints in adjacent rear seating positions,
you can use the ISOFIX anchors or the vehi-
cle's seat belt for the outboard position, but you
must use the vehicle's seat belt at the center
position. If your child restraints are not ISOFIX-
compatible, you can only install the child re-
straints using the vehicle's seat belts. For typi-
cal installation instructions, refer to "Installing
the ISOFIX-Compatible Child Restraint Sys-
tem".
Installing the ISOFIX-Compatible Child
Restraint System
We urge you to carefully follow the directions of
the manufacturer when installing your child
restraint. Not all child restraint systems will be
installed as described here. Again, carefully
follow the installation instructions that were pro-
vided with the child restraint system.
The rear seat lower anchorages are round bars,
located at the rear of the seat cushion where it
50
meets the seatback, and are just visible when
you lean into the rear seat to install the child
restraint. You will easily feel them if you run your
finger along the intersection of the seatback
and seat cushion surfaces.
art=022609609.tif NO TRANS
ISOFIX Anchorages
In addition, there are top tether strap anchor-
ages behind each rear seating position located
on the back of the outboard seats. To access
the top tether strap anchorages behind the rear
seat, pull the carpeted floor panel away from
the seat back, this will expose the top tether
strap anchorages.
art=022634157.tif NO TRANS
Pulling Down The Carpet Floor Panel To
Access Top Tether Strap
art=022634158.tif NO TRANS
Top Tether Strap Anchorage (Located on
Seatback)