Table of Contents
Advertisement
JOBNAME: CHRY OM INTL (Conten PAGE: 258 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 25FB4941
/chry_pdm/chrysler/owners/grc/og
art=051810686.tif
NOTE:
When shifting out of transfer case NEUTRAL
(N), turning the engine OFF may be required
to avoid gear clash.
9. Shift the transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
256
NO TRANS
Neutral Switch
15. Shift the transmission into DRIVE, release
the brake pedal, and check that the vehicle
operates normally.
16. The
Keyless
Enter-N-Go
equipped) may now be reinstalled if desired.
Refer to "Starting Procedures/Keyless Enter-N-
Go" in "Starting and Operating" for further
information.
NOTE:
• Steps 1 through 7 are requirements that
must be met prior to pressing the NEU-
TRAL (N) button, and must continue to be
met until the shift has been completed. If
any of these requirements are not met
prior to pressing the NEUTRAL (N) button
or are no longer met during the shift, the
NEUTRAL (N) indicator light will flash
continuously until all requirements are
met or until the NEUTRAL (N) button is
released.
• The ignition switch must be in the ON/
RUN position for a shift to take place and
for the position indicator lights to be op-
erable. If the ignition switch is not in the
ON/RUN position, the shift will not take
place and no position indicator lights will
be on or flashing.
• A flashing NEUTRAL (N) position indica-
button
(if
tor light indicates that shift requirements
have not been met.
Advertisement
Chapters
Table of Contents
