Easy Entry/Exit Seat; To Open And Close The Hood - Jeep Grand Cherokee WK2 Owner's Manual

JOBNAME: CHRY OM INTL (Conten PAGE: 105 SESS: 2 OUTPUT: Fri Jun 4 10:52:37 2010 SUM: 454C978A
/chry_pdm/chrysler/owners/grc/og
NOTE:
Once programmed, all RKE transmitters
linked to memory can be easily enabled or
disabled at one time. Refer to "Electronic
Vehicle Information
Customer-Programmable Features" in "Un-
derstanding Your Instrument Panel" for fur-
ther information.

Easy Entry/Exit Seat

This feature provides automatic driver's seat
positioning which will enhance driver mobility
out of and into the vehicle.
There are two possible Easy Entry/Exit adjust-
ments available:
• The seat cushion will move rearward ap-
proximately 2.5 in (60 mm), if the starting
position of the seat is greater than or equal to
2.67 in (68 mm) forward of the rear seat stop
when the key is removed from the ignition
switch. The seat will then move forward
approximately 2.5 in (60 mm) when the key is
placed into the ignition and turned out of the
LOCK position.
• The seat will move to the position located
0.3 in (8 mm) forward of the rear stop if the
starting position is between 0.9 to 2.67 in (23
to 68 mm) forward of the rear stop when the
key is removed from the ignition switch. The
Center (EVIC)/
seat will move forward to the memory/driving
position when the key is placed into the
ignition, and turned out of the LOCK position
toward the ACC/ON position.
The Easy Entry/Exit feature will be automatically
disabled if the seat is already positioned closer
than 0.9 in (23 mm) forward of the rear stop. At
this position, there is no benefit to the driver by
moving the seat for Easy Exit/Entry.
Each stored memory setting will have an asso-
ciated Easy Entry/Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the fac-
tory. The Easy Entry/Exit feature is enabled
(or later disabled) through the program-
mable features in the Electronic Vehicle In-
formation Center (EVIC). Refer to "Elec-
tronic Vehicle Information Center (EVIC)/
Customer-Programmable Features"
"Understanding Your Instrument Panel" for
further information.

TO OPEN AND CLOSE THE HOOD

To open the hood, two latches must be re-
leased.
1. Pull the release lever located below the
instrument panel and in front of the driver's
door.
art=031309526.tif NO TRANS
Hood Release
2. Reach under the hood, move safety latch to
the left and lift the hood.
in
103