Adjusting The Image - Christie DS4K User Manual

3.5 Adjusting the
Image
Before You Begin
•
AUTO SOURCE:
this channel when an incoming input signal matches. If not checked, the
projector can locate the selected channel only when it is directly selected via
on the keypad—and a change in input signal will not result in a channel
Channel
change.
•
If checked, all of the image settings for this channel are disabled. If
LOCKED:
unchecked (default), all available image settings can be adjusted as desired.
You cannot use Auto Setup with a locked channel.
•
PREVIOUS CHANNEL:
for the previous channel in the Channel Setup list.
•
NEXT CHANNEL:
the next channel in the Channel Setup list.
The most commonly used options for image adjustments are accessed through two
menus: Size and Position (
appear in the Main menu. From either of these two menus, you can change settings
affecting the image from the current channel by working with the appropriate
slidebars, checkboxes and pull-down lists.
the presentation, if from the Main menu) and accept any changes you may have
entered. Settings are saved with the current channel.
From your presentation, you can access any of the individual options in these menus
by pressing followed by the appropriate two-digit number representing their
Menu
location in the menu system. For example, press
"Gamma" option in the Image Settings menu.
Note that for certain options, you may prefer to use a "direct key" from presentation
level to go directly to a particular option without traveling through the menu system
(note: available for certain display parameters only). For example, press
access the "contrast" slidebar immediately. Press
NOTES: 1) To hide these "direct" slidebars, disable the "Display Slidebars"
checkbox in the Menu Preferences menu. 2) To hide the entire menu system from
view, toggle the on-screen display by pressing
'
Use Auto Setup (
For a good and efficient first step in perfecting the image, press
automated process in which the projector quickly optimizes critical display parameters
such as size, position, pixel tracking, etc., based on the type of incoming source data
detected. An Auto Setup can save considerable setup time, and you can still modify
the adjustments as desired using menu options described below.
If checked, (default), the projector can automatically locate
Select this option to see or change Channel Edit settings
Select this option to see or change Channel Edit settings for
1
Menu
)and Image Settings (
Exit
Auto
)
Section 3: Operation
2
Menu
), both of which
will return to the previous menu (or to
2 3
Menu
to quickly access the
to return to your presentation.
Exit
OSD .
Auto . This initiates an
User's Manual
Contrast to
3-19
.