Christie DS4K User Manual page 99

5. Align the new lamp with the top and bottom guides on the left side of the
lamp compartment. (Figure 4.5.) Slide the lamp all the way in – a slightly
harder push may be required right at the end to make sure it is fully seated
into the terminal block. NOTE: The projector will not power up again if the
lamp is not fully connected to the terminal block.
6. Pull (out) and turn the lamp lock lever (turned up in Step 3) a quarter turn
clockwise to "lock" the lamp in place. NOTE: If you can't turn the lamp lock
into position it is likely the lamp is not fully inserted. In this case, partially
remove the lamp and try pushing it back in again. Then, try switching the lock
lever to the "lock" position.
7. Replace the lamp door and tighten the 2 screws to secure.
8. The next time the projector is powered up, enter the new serial number of the
newly installed lamp. Access the Lamp menu and select "Change Lamp".
Enter the serial number in the Lamp S/N text box using the number text entry
keys.
Figure 4.4.
Figure 4.5.
Section 4: Maintenance
User's Manual 4-7
.