Table of Contents
Advertisement
Section 1: Introduction
How the projector works
1.2
Components
1.3
Purchase
Record and
Servicing
1-2
'
The projector accepts data/graphics and video input signals for projection onto front
or rear flat screens. High brightness light is generated by an internal Xenon lamp then
modulated by three DMD (digital micromirror device) panels that provide digitized
red, green or blue color information. Light from the "on" pixels of each panel is
reflected, converged and then projected to the screen through a single front lens,
where all pixels are perfectly superimposed as a sharp full-color image (2D or 3D for
Mirage models only).
The following listed items are shipped with your projector. Ensure you have received
all these items before using your projector.
•
User's Manual
•
IR remote keypad (includes two, 1.5V AA batteries and a mini-stereo cable for
conversion to wired)
•
Line cord
•
Stereo 3D Cable
•
Warranty Card
Whether the projector is under warranty or the warranty has expired, Christie's highly
trained and extensive factory and dealer service network is always available to quickly
diagnose and correct projector malfunctions. Service manuals and updates are
available to service technicians for all projectors.
If you encounter any problems with the projector and require assistance, contact your
dealer or Christie Digital Systems. Fill out the information in the table below and keep
with your records for future reference.
Dealer:
Dealer Phone Number:
Projector Serial Number:
Purchase Date:
Installation Date, if applicable:
NOTE: The serial number can be found on the license label, which is located at the back of the projector.
You can also register your product on-line by visiting www.christiedigital.com ⇒
Service and Support ⇒ Product Registration. This will keep you in touch with all
the latest product information, such as updates, technical bulletins, downloads and
Christie newsletters.
Purchase Record
User's Manual
Advertisement
Table of Contents
