Christie DS4K User Manual page 59

Section 3: Operation
Figure 3.15. Using the "Network Routing" Option
Messages originating from an RS232 or RS422 controller
RS232 AND RS422 JOINED:
will be relayed to all RS232 ports. Any Ethernet communication, however, will not.
Messages to and from the RS232 ports will also be
RS232 AND ETHERNET JOINED:
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
All messages reach all ports, regardless of type.
ALL JOINED:
Ethernet Settings
(SUBMENU)
NOTES: 1) Recommended for network administrators only.
Enable this checkbox if you want a DHCP server to automatically change the
DHCP:
projector's default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new "IP
Address" settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service and only when the DHCP checkbox is enabled.
Enter a valid and unique IP address for use on the network to which the
IP ADDRESS:
projector is currently connected. This address will overwrite any previous IP address
such as the projector's factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. An IP address entered here remains in effect until it is
changed again.
On some Ethernet networks, firewall restrictions may require that the port
PORT:
number of the projector be changed from its default of 3002. If so, enter a new valid
port number here.
User's Manual 3-37
.