Christie DS4K User Manual page 100

Section 4: Maintenance
Filter Replacement
4-8
'
The two filters located at the front
and left side of the projector
should be replaced whenever the
lamp is replaced. If you are
working in an extremely dusty
environment you may want to
replace the filters sooner. Use the
filters provided in the Christie
approved Lamp and Filter Kit for
your specific projector model
(Table 1.)
Tools required: #1 Phillips
screwdriver
1. Loosen the screw(s) from the
filter access panels. The front
access panel is located to the
left of the projection lens – 1
screw. Left side access panel –
3 screws. See Figure 4.6.
2. Pull the filters out of the
projector and discard. Do not
reuse filters.
3. Insert the new filters with the
wired side in. (Figure 4.7.)
4. Replace the filter access panels
and tighten the screws to
secure.
User's Manual
Figure 4.6.
Figure 4.7.