Christie DS4K User Manual page 45

Section 3: Operation
H-Position
This option moves the image right or left within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies in
relation to the total number of pixels available horizontally. This varies widely
according to the signal—watch the image while adjusting.
V-Position
This option moves the image up or down within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies in
relation to the total number of pixels available vertically. This varies widely
according to the signal—watch the image while adjusting.
Swap PIP Images
Toggle the current picture-in-picture relationship so that the primary image becomes
secondary, and the secondary image becomes primary. Swapping is available only
when PIP is enabled. Note: Not available in v1.0 software. Shown as "Reserved".
PIP Enable
Toggle to display from two sources at once (picture-in-picture) or the primary source
only. This checkbox turns the secondary source on and off in the display. Note: Not
available in v1.0 software. Shown as "Reserved".
Advanced Size and Position
— SUBMENU
This submenu consists of the
following options:
This read-
ACTIVE INPUT WINDOW:
only value indicates the current
size (i.e., area) of your displayed
data or "region of interest" as
defined by the blanking controls.
By default, the projector
automatically determines what portion of its full resolution to use, and pixels in the
surrounding borders are turned off. You can also specify a specific active input
window size by adjusting one or more "Blank" settings. For example, if you have
blanked (cropped) 100 pixels from both the left and right edges of an incoming source
of 1400 x 1050, the remaining active input window will be reduced to 1200 x 1050.
When using SD or HD or a decoded video source at or , the default
INPUT 3 INPUT 4
blanking of "0" defines an active input window of 720 x 483.
User's Manual 3-23
.