Christie DS4K User Manual page 28

Section 3: Operation
3-6
Table 3.1. Auto Setup
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
NOTE: You must have an unlocked channel present to use Auto Setup.
Channel
Channel
Channel
Press to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
the Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
enter the desired channel number "blind", i.e., without on-screen feedback. See Menu
Preferences later in this section.
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
Input 2
Input 2
Press to display from the DVI source connected to
Input 2
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
Input 5
Input 5
Press to display from the
Input 5
NOTE: If you have the optional Dual SD/HD-SDI Module installed and there are two
inputs connected here, the second input (B) is considered
built-in keypad or the
remote keypad, press
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 5
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
display from the other Dual SD/HD-SDI Module input.
What an "Auto Setup" Does
), the display will automatically change and update
Channel
) key behavior during a presentation depends on whether or not
INPUT 5
interface module installed in the Option 1 slot.
INPUT 5 INPUT 7
to access
INPUT 5
, press
User's Manual
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
Channel
, or you may prefer to
INPUT 2
.
INPUT 4
INPUT 7.
as follows:
again. This switches to
Input 5
INPUT 5 INPUT 7
or , depending on which of
INPUT 1
.
INPUT 3
.
.
If you are using the
INPUT 7
.
again to
Input 5