FLIR Exx series User Manual page 55

Publ. No. T559597 Rev. a500 – ENGLISH (EN) – December 10, 2010
3 On the meter, enable Bluetooth mode. Refer to the user documentation for
the meter for information on how to do this.
4 On the meter, choose the quantity that you want to use (voltage, current,
resistance, etc.). Refer to the user documentation for the meter for informa-
tion on how to do this.
Results from the meter will now automatically be displayed in the result table
in the top left corner of the infrared camera screen.
5 Do one of the following:
To preview an image, push the Preview/Save button. At this stage, you
■
can add additional values. To do so, take a new measurement with the
meter and select Add on the infrared camera screen.
To save an image without previewing, push and hold down the Pre-
■
view/Save button.
To add a value to a recalled image, turn on the meter after you have re-
■
called the image, then select Add on the infrared camera screen. A
maximum of eight values can be added, but note that some values are
broken into two lines.
16 – Fetching data from external Extech meters
43