Cmos Setup - VersaLogic EPM-15 Reference Manual

CMOS Setup

The default CMOS Setup parameters for the EPM-15 are shown below.
+------------------------------------------------------------------------------+
|
| (C) 2005 General Software, Inc. All rights reserved
+---------------------------+--------------------+-----------------------------+
| DRIVE ASSIGNMENT ORDER:
| Drive A: (None)
| Drive B: (None)
| Drive C: Ide 0/Pri Master +--------------------+ Show "Hit Del"
| Drive D: (None)
| Drive E: (None)
| Drive F: (None)
| Drive G: (None)
| Drive H: (None)
| Drive I: (None)
| Drive J: (None)
| Drive K: (None)
| Boot Method: Boot Sector
+---------------------------+ Ide 0: 3 = AUTOCONFIG, LBA
| FLOPPY DRIVE TYPES:
| Floppy 0: Not installed
| Floppy 1: Not installed
+---------------------------+--------------------------------------+-----------+
+------------------------------------------------------------------------------+
|
| (C) 2005 General Software, Inc. All rights reserved
+---------------------------------------+--------------------------------------+
| ACPI 1.0
| POST Memory Manager
| System Management BIOS
| Console Redirection
| UsbMassStorage
+---------------------------------------+--------------------------------------+
+------------------------------------------------------------------------------+
|
| (C) 2005 General Software, Inc. All rights reserved
+---------------------------------------+--------------------------------------+
| PCI INT A Assignment
| PCI INT B Assignment
| PCI INT C Assignment
| PCI INT D Assignment
| Write protect BIOS
| Video buffer size
| Flat panel display
| Video refresh rate
| Video data width
| Primary video device
| Memory timings
| CPU Temp threshold
| CPU overtemp IRQ
| CPU/Memory speeds
| Periodic SMM IRQ
+---------------------------------------+--------------------------------------+
EPM-15 Reference Manual
Basic CMOS Configuration
System BIOS Setup - Basic CMOS Configuration
| Date:>Apr 09, 2009 | Typematic Delay
| Time: 00 : 00 : 00 | Typematic Rate
| NumLock:
| BOOT ORDER:
| Boot 1st: Drive C: | F1 Error Wait
| Boot 2nd: (None)
| Boot 3rd: (None)
| Boot 4th: (None)
| Boot 5th: (None)
| Boot 6th: (None)
+--------------------+-----------------+-----------+
| ATA DRV ASSIGNMENT:
| Ide 1: 3 = AUTOCONFIG, LBA
| Ide 2: Not installed
| Ide 3: Not installed
Features Configuration
System BIOS Setup - Features Configuration
:>Enabled
: Disabled
: Enabled
: Auto
: Enabled
Custom Configuration
System BIOS Setup - Custom Configuration
:>IRQ 11
: IRQ 11
: IRQ 11
: IRQ 9
: Enabled
: 32 MB
: Disabled
: 60 Hz
: 1 pix/clk
: Auto
: Optimal
: 80*C
: Disabled
: 500/333 MHz
: Enabled
Disabled | Seek at Boot
| Config Box
| Parity Checking
| Memory Test Tick : Enabled
| Debug Breakpoints: (Unused) |
| Debugger Hex Case: Upper
| Memory Test : StdLo
Sect Hds Cyls | Memory
| System Management Mode
| Splash Screen
| Primary IDE UDMA
| Firmbase Debug Console
| Usb20
| ISA IRQ 3
| ISA IRQ 4
| ISA IRQ 10
| Reserved
| Reserved
| LPT1 (378) Enable/IRQ : No IRQ
| Parallel Port Mode
| COM1 (3F8) RS-232
| COM3 (3E8) RS-422/485 : Disabled
| COM4 (2E8) RS-422/485 : Disabled
| Reserved
| BIOS extension
| Legacy USB support
| IDE cable type
|
Configuration and Setup
|
|
: 250 ms |
: 30 cps |
: None |
: Enabled |
: Enabled |
: Enabled |
: (Unused) |
|
|
FastHi |
|
| Base: |
| 632KB |
| Ext: |
| 219MB |
|
|
: Enabled |
: Disabled |
: Enabled |
: None |
: Enabled |
|
|
: Disabled |
: Disabled |
: Disabled |
: Reserved |
: Reserved |
|
: Printer |
: IRQ4 |
|
|
: Reserved |
: Disabled |
: Enabled |
: 40-Wire |
|
11