Table of Contents
Advertisement
3. Review Configuration
Before you power up the system, double check all the connections. Make sure all cables
are oriented correctly and that adequate power will be supplied to the EPM-15 and
peripheral devices.
4. Power On
Turn on the ATX power supply and the video monitor. If the system is correctly
configured, a video signal should be present.
5. Change CMOS Setup Settings
Enter CMOS Setup by pressing Delete during the early boot cycle.
Select Basic Configuration and set or verify the following settings:
DRIVE ASSIGNMENT ORDER | Drive C: Ide 0/Pri Master
ATA DRV ASSIGNMENT | Ide 0: 3 = AUTOCONFIG, LBA
ATA DRV ASSIGNMENT | Ide 1: 5 = IDE CDROM
BOOT ORDER | Boot 1st: CDROM
BOOT ORDER | Boot 2nd: Drive C:
Before saving the CMOS Setup settings, insert the Windows (or other OS) installation
disk in the CD-ROM drive so it will be accessed when the system reboots.
Press ESC and select the option to save the new parameters to CMOS RAM. The system
will reboot.
6. Install Operating System
Install the operating system according to the instructions provided by the OS
manufacturer. (See Operating System Installation.)
Note: If you intend to operate the EPM-15 under Windows XP or Windows XP
Embedded, be sure to use Service Pack 2 (SP2) for full support of the latest CS5536 I/O
hub and its USB 2.0 features.
EPM-15 Reference Manual
Configuration and Setup
10
Advertisement
Table of Contents
