VersaLogic EPM-15 Reference Manual page 15

Analog SVGA
CBR– 1201
1. Attach Power
Plug the power adapter cable CBR-1008 into socket J9. Attach the motherboard
connector of the ATX power supply to the adapter.
2. Attach Cables and Peripherals
Plug the video adapter cable CBR-1201 into socket J1. Attach the video monitor interface
cable to the video adapter.
Plug the breakout cable CBR-5009A into socket J8. If necessary, attach the breakout
board CBR-5010B to the cable. (The cable and board are shipped attached.)
Plug a USB keyboard and USB floppy drive into socket J4 of the breakout board.
Plug the hard drive data cable CBR-4406 into socket J7. Attach a hard drive and CD-
ROM drive to the connectors on the cable. If the hard drive is 3.5", use the 2mm to 0.1"
adapter CBR-4405 to attach the IDE cable.
Attach an ATX power cable to any 3.5" drive (hard drive or CD-ROM drive).
Set the hard drive jumper for master device operation and the CD-ROM drive jumper for
slave device operation.
EPM-15 Reference Manual
EPM-15
"Manx"
J1
J9
CBR– 1008
ATX
Power Supply
Figure 3. EPM-15 Typical Start-up Configuration
CBR – 5009A
J8
J7
CBR– 4406
Hard
Drive
CD-ROM
Drive
Power
to
Drives
Configuration and Setup
USB Keyboard
and USB Mouse
J1 J4
CBR – 5010B
OS Installation
CD-ROM
9